Art SLA-4 User's Guide

SLA-4 FOUR CHANNEL STUDIO LINEAR AMPLIFIER USER’S GUIDE

REAR PANEL CONNECTIONS It is easy to interface the SLA-4 with a wide variety of equipment. All inputs and outputs are located on the rear panel.

STEREO / BRIDGE AMP MODE SWITCHES The SLA-4 Amp Mode Switches allow you to choose between Stereo and Bridged Mono Modes. Two separate switches a

Spade Connector – Loosen the red and black caps on the binding posts (don’t completely remove). Insert the spade connector into the binding post

FUSE The SLA-4 utilizes a (T10A 250v 20mm) 10 Amp fuse. Be sure to replace blown fuses with a fuse of equal rating only. AC POWER INPUT The S

OPERATION Connect source audio material directly into each input channel and set the channel level controls to provide an appropriate level into each

15 PROTECTION The SLA-4’s output circuitry is fully protected from short circuits. An ultrasonic network decouples RF from the output and helps kee

WARRANTY INFORMATION Limited Warranty Applied Research and Technology will provide warranty and service for this unit in accordance with the follow

- 17 - SERVICE The following information is provided in the unlikely event that your unit requires service. 1) Be sure that the unit is the cause o

SLA-4 SPECIFICATIONS Dimensions 1.75”H x 19.0” W x 13.5”D 44.5mm x 482.6mm x 190.5mm Weight 19.8 lbs., 9.0kg. Input Connections

- 19 -

2

www.artproaudio.com E-mail: [email protected] © 2008 Applied Research & Technology Four Channel Studio Linear Ampli

The ART SLA-4 FOUR CHANNEL STUDIO LINEAR AMPLIFIER IMPORTANT SAFETY INSTRUCTIONS - READ FIRST ... 4 INTRODUCTION ...

IMPORTANT SAFETY INSTRUCTIONS – READ FIRST This symbol, whenever it appears, This symbol, wherever it appears, alerts alerts y

INTRODUCTION Thank you for purchasing the ART SLA-4 Four Channel Studio Linear Amplifier and congratulations, you now own one of the most versatile l

INSTALLATION The SLA-4 may be used in a wide variety of applications from project or professional studio environments to commercial sound installatio

SECURITY COVER For commercial installations it may be desirable to set the gain controls on the power amp, and then make them inaccessible to non-q

CONTROLS & INDICATORS – FRONT PANEL POWER SWITCH The Power Switch is located on the front of the unit, directly in the center. During initia

9 PROTECT INDICATOR LED The LED will glow when the channels associated with it go into protect mode. In protect mode, the output signal to the spea